Hi everyone - looking for some help to get my project off the ground. My goal is to read CAN bus and/or ODBII PID data using an Adafruit ESP32 feather and a Waveshare SN65HVD230. I will upload a pic of the wiring schematic but I feel pretty confident in that, as well as the pinout from my OBDII connector. CAN high/low both measure ~2.5V with a multimeter straight off the port in my VW, and those are attached via screw terminal to the Waveshare. Waveshare has power and ground, and the OBDII pinou
SN65HVD230 for ESP32, some suggestion : r/PrintedCircuitBoard
2-Channel Isolated CAN Bus Expansion HAT Compatible with Raspberry Pi/Arduino/STM32,2-CH CAN HAT with MCP2515 + SN65HVD230 Dual Chips Solution,Multi Onboard Protection Circuits : Electronics
How to get the best out of this forum - IDE 1.x - Arduino Forum
Arduino ESP32 Crawler Powered by CAN
2-Channel Isolated CAN Bus Expansion HAT Compatible with Raspberry Pi/Arduino/STM32,2-CH CAN HAT with MCP2515 + SN65HVD230 Dual Chips Solution,Multi Onboard Protection Circuits : Electronics
DescriptionWaveshare CAN Board SN65HVD230Features an accessory onboard CAN transceiverIs used to connect MCUs to the CAN networkIs powered from 3.3
Waveshare CAN Board SN65HVD230
RS485 CAN BUS HAT MCP2515 Raspberry pi and Arduino
Is my esp32-cam broke? - Storage - Arduino Forum
ESP32/Waveshare SN65HVD230 CAN - Device Hacking - Arduino Forum
RS485 CAN BUS HAT MCP2515 Raspberry pi and Arduino
2-Channel Isolated CAN Bus Expansion HAT Compatible with Raspberry Pi/Arduino/STM32,2-CH CAN HAT with MCP2515 + SN65HVD230 Dual Chips Solution,Multi Onboard Protection Circuits : Electronics